Gen III+ Fuel Pump Integration Kits
for
Jeep Grand Wagoneers, 1981–1991
GM Gen. III+ LS and Vortec engines need far more fuel pressure (~58 PSI at the rail) than the factory Grand Wagoneer fuel system was built to supply. Novak’s integration kits put a high-pressure electric pump inside the factory tank and supply everything needed to connect it to the GM engine’s fuel rail — no external pump, no fuel cell.
Choosing Your Kit
- Years: 1981–1985 and 1986–1991 Grand Wagoneers use different fuel level sending units, and each kit includes a new sending unit for its years. Pick your Jeep’s model year.
- Regulator: most Gen. III+ swaps need the regulator (see below). Choose “Not included” only when your engine already has its own pressure regulator.
With Pressure Regulator (FSK-JW4, FSK-JW3)
Includes a pressure regulator / filter combination (the 1999–2003 Corvette LS style) that supplies ~58 PSI to the fuel injection rail through a return-less supply line. This is for Gen. III+ engines that require a regulator external to the GM fuel rail.
Without Pressure Regulator (FSK-JW4NR, FSK-JW3NR)
The same kit without the regulator, for Gen. III engines that already have the factory regulator integrated into the fuel rail — typically many 1997–2002 GM LS / Vortec engines. On those engines you will see a diaphragm-style regulator on the rail and a return line in addition to the supply line. Check your engine before ordering, or call us if you aren’t sure which you have.
An example of the regulator found on earlier LS-style fuel rails. These engines always have both a supply line and a return line.
What’s Included
- In-tank electric fuel pump, 90 PSI / 130 LPH, with pre-filter strainer
- New Grand Wagoneer fuel level sending unit for your years (1981–1985 or 1986–1991)
- Isolator bolt kit for the sending unit
- Inline high-pressure fuel injection filter (5/16″ inlet, 3/8″ outlet)
- Fuel pressure regulator with integrated filter — regulated kits only
- High-pressure fuel injection hose, plus regular-pressure fuel-safe hose and high-temperature fuel-safe hose
- Quick-connect fuel line fittings
- Double-pinch and standard hose clamps
- Pump wiring: 16-gauge red and black wire, a Metri-Pack 150 two-way sender connector with terminals and secondary lock, ring terminals, a relay blade terminal, and a screw and nut
Installation Requirements
The kit replaces the factory fuel sending unit, so the sending unit must come out of the fuel tank; work with the tank as empty as possible. General hand tools are required. The pump is wired to the fuel pump circuit of your GM engine’s wiring harness.
Any person or shop working on any factory or conversion vehicle fuel system must consider that any open flame or electrical spark or tool spark in the proximity to fuel and especially fuel vapors can cause massive damage to life, health and property. Improper electrical connections can spark, overheat and ignite fuels and their vapors. If the installer is not qualified to work on a vehicle fuel system, they should seek the consulting and installation services of someone who is competent in this area.
LIVE CHAT
Sales / Scratch & Dent
