GM Generation III+ V8 Engine Mounts
FSJ Full-Size Wagonner / J-Truck / Cherokee Jeeps
New for 2011 are Novak's weld-in engine mounts for the Jeep FSJ Trucks, providing immense strength and a precise GM Generation III+ V8 engine installation.
Ease of Installation
These mounts are bolt-in style and detailed instructions will guide the installer for an ideal installation. We do recommend a weld be placed on these mounts for the best strength acheivable.
Unbolting and removal of the factory frame mounts for factory Tornado, Buick and AMC engines is required.
The Novak mounts feature a thick 3/16 steel construction and a welded box design for the maximum strength available. They employ the best engineering and geometry to assure that they'll survive even the wildest V8's.
We have predetermined engine placement for the installer. There is a very fine window in which the GM Gen. III+ V8 can properly fit into a FSJ Jeep, and we've done this design legwork already. The mounts will offest the engine the recommended amount to the passenger side for optimal brake booster and heater unit clearance.
The mounts keep themselves out of the way of the steering and its pillow block, allowing the installer to keep the entire Jeep steering system intact and undisturbed. They will also clear the exhaust headers we recommend, our CCLS1 series blockhuggers. Clearance from all other retained factory components is also excellent.
Each mount kit comes with our high-grade urethane isolators that are gauged well for that ideal balance of isolation and firmness. The large, graded 5/8” bolts and all associated hardware are included. Additionally, Novak will always be here to inexpensively provide replacement urethane bushings, if needed - years down the road.
Engine Mount Finish
You may enamel, powercoat or otherwise finish the bracketry and adjacent frame area to your own style.
These Mounts are applicable to the following Jeeps & engines:
If you're seeking engine mounts for the Chevrolet Small Block V8's, see them here.