GM Generation III+ V8 Engine Mounts
JK Wrangler Jeeps
Novak's engine mounts for the Jeep JK Wranglers provide immense strength and a rapid and precise GM Vortec & LS V8 engine installation.
Ease of Installation
Our JK engine mounts are engineered to be welded directly to the Jeep frame. Their geometry lends themselves to easy and accessible welds. The engine can then be lowered into place and secured with the provided hardware.
The Novak mounts feature a thick 3/16 steel construction and a box design for the maximum strength available. They employ the best engineering and geometry to assure that they'll survive even the wildest V8's.
Our JK engine mount set will position themselves at the precise height and offset for optimal placement of a Generation III+ GM V8 into the Jeep JK Wrangler. They index positively to the frame for the installer's total confidence.
The mounts keep themselves out of the way of the steering, allowing the installer to keep the entire Jeep steering system intact and undisturbed. They will also clear the exhaust headers we recommend. Unlike mounts for JK Hemi conversions that require special bump stops to limit suspension travel, these mounts allow for the full front axle compression. Clearance from all other retained factory components is also excellent.
|The Novak frame bracket, as attached to the Jeep frame and GM engine.|
Each mount kit comes with our high-grade nitrile isolators that are gauged well for that ideal balance of isolation and firmness. The large, graded 5/8” bolts and all associated hardware are included. Additionally, Novak will always be here to inexpensively provide replacement isolators, if needed - years down the road.
The factory engine mounts and frame brackets will be removed and fully replaced by our mount kit. Novak's JK mounts will allow for a small degree of fore / aft adjustment, however, it is recommeded they be placed as designated for an optimal installation.
These Mounts are applicable to the following Jeeps & engines: